Logicube F-FALCON-SA User Manual page 87

Logicube Forensic Falcon™ User's Manual
To set a macro to perform a Wipe using Secure Erase on SAS_D1,
immediately followed by performing a Drive to Drive image from
SAS_S1 to the newly wiped (secure erased) SAS_D1, the Wipe and
Imaging Tasks first need to be set up.
1. First, set the Wipe task. Select SAS_D1 as the
Destination and change the setting to perform a Secure
Erase (Wipe Patterns and Format set to off). Do not
start this task.
2. Next, set the Imaging task. Select Drive to Drive as the
Mode. Select SAS_S1 as the Source. Change the settings
as needed. Select SAS_D1 as the Destination. Do not
start this task.
3. Choose Task Macro from the list of operations on the
left side.
4. Tap the Tasks icon to select the different tasks for the
macro.
5. Tap the field next to Operation 1 to set the first
operation. Since the first task to be run is the Wipe task,
select Wipe 1 then tap
6. Tap the field next to Operation 2 to set the second
operation. Since the second task to be run is the Drive
to Drive Imaging task, select Image 1 then tap OK.
7. The screen should now show Wipe 1, Image 1 as the
Tasks for Macro 1.
TYPES OF OPERATIONS
OK.
78