Changing Only The Logicube Password - Logicube F-FALCON-SA User Manual

7. Next, to change the "it" password, type the following command then
8. The following prompt will appear:
9. Type a new password then press the Enter key. The following prompt
10. Type the new password again then press the Enter key. The following
11. Type the following command then press the Enter key:
12. Press the following key combinations to go back to the Graphical User

16.0.2 Changing only the logicube password

For the username: logicube
1. Connect a USB keyboard one of the two USB ports in front of the Falcon
2. Once logicube prompt appears, type the following commands, one line
3. The following prompt will appear:
4. Type the current password (by default, "logicube" without the quotes)
5. Type a new password then press the Enter key. The following prompt
6. Type the new password again then press the Enter key. The following
Logicube Forensic Falcon™ User's Manual
passwd: password updated successfully
press the Enter key:
sudo passwd it
Enter new UNIX password:
will appear:
Enter new UNIX password:
response should appear:
passwd: password updated successfully
sudo mount -o remount,ro /
Interface: Alt+1
then use the following key combinations: Alt+2 then Alt+Shift+Enter.
at a time (Press the Enter key after each command/line):
sudo mount -o remount,rw /
passwd
Changing password for logicube.
(current) UNIX password:
then press the Enter key. The following prompt will appear:
Enter new UNIX password:
will appear:
Retype new UNIX password:
response should appear:
CHANGING DEFAULT PASSWORDS
153