Logicube F-FALCON-SA User Manual page 127

2. Select the encrypted disk to mount (in this example, it is Disk #5). Place
3. In the Key tab, enter the Key (password) and make sure the Hash is set
4. In the Encryption tab, set the Cipher to AES (256 bit CBC). Set the
Logicube Forensic Falcon™ User's Manual
a check mark on the Entire disk option. FreeOTFE cannot read the
partition table on the drive since it is encrypted at this time.
to RIPEMD-160.
Initialization Vector (IV) generation method to match what was used in
the IV Generation on the Falcon. In this example, "plain64' was used. In
the 'Sector zero location', choose Start of encrypted data.
DRIVE ENCRYPTION & DECRYPTION
118