Usb Device (Viewing Drive Contents In Windows); Step-By-Step Instructions - Usb Device - Logicube F-FALCON-SA User Manual

4. Set up to 9 operations by tapping on each operation in order (Operation
5. When all the operations have been set, tap the OK icon.
6. Tap the Start icon to execute the macro and perform all the operations
7. When finished, the status will show "COMPLETED". At this point, it is

3.6 USB Device (Viewing drive contents in Windows)

Connecting the Falcon to a computer via USB allows the user to view any drive
connected to the Falcon. In this mode, all drives connected to the Falcon are
write-protected.
1. Select USB Device from the types of operation on the left side.
2. In the Export tab, a list of drives connected to the Falcon will appear.
3. Connect a USB 3.0 cable (A-to-B) between a computer and the Falcon.
4. Windows will automatically detect the drive, install the drive's drivers (if
5. The new drive letter will contain the contents of the selected drive and
Logicube Forensic Falcon™ User's Manual
1, Operation 2, etc.)
within that macro.
recommended to tap Reset Task to reset the task, and also to delete the
task in order for the drive bays to be properly reset and not show as
being used or assigned for other tasks to be configured.
2.7.1 Step-by-step instructions – USB Device
Select a drive then tap the Engage icon.
Connect the A connector side of the cable to an available USB port on
the computer, and connect the B connector side of the cable to the back
panel of the Falcon.
necessary), and should assign it a drive letter.
is write-protected.
QUICK START
27