Installing Or Removing The Compact Flash Memory Card - Cisco IE 3000 Hardware Installation Manual

Appendix B Installation In a Hazardous Environment

Installing or Removing the Compact Flash Memory Card

Figure B-6 Pushing the Module Latches In
If you are going to install a second expansion module to the switch expansion module combination,
Step 6
follow Step 1 to Step 5
Refer to Table B-1 for a list of supported switch and expansion module combinations.
Note
Installing or Removing the Compact Flash Memory Card
The switches store Cisco IOS software images and switch configurations on a removable flash memory
card. You can replace the switch without reconfiguring it. The switch ships with the compact flash
memory card installed. Verify that the card is in place on the bottom of the switch.
Do not insert or remove the compact flash card while power is on; an electrical arc can occur. This
Warning
could cause an explosion in hazardous location installations. Be sure that power is removed or the
area is nonhazardous before proceeding. Statement 379
Cisco IE 3000 Switch Hardware Installation Guide
B-14