Disconnect Power; Installing The Switch - Cisco IE 3000 Hardware Installation Manual

Installing the Switch

Disconnect Power

After successfully running POST, follow these steps.
Step 1 Turn off power to the switch.
Disconnect the cables.
Step 2
Decide where you want to install the switch.
Step 3
Installing the Switch
This section describes how to install the switch:
•
•
•
This equipment is supplied as "open type" equipment. It must be mounted within an enclosure that is
Warning
suitably designed for those specific environmental conditions that will be present and appropriately
designed to prevent personal injury resulting from accessibility to live parts. The interior of the
enclosure must be accessible only by the use of a tool.
The enclosure must meet IP 54 or NEMA type 4 minimum enclosure rating standards. Statement 1063
To prevent the switch from overheating, ensure these minimum clearances:
Caution
– Top and bottom: 4.13 in. (105 mm)
– Exposed side (not connected to the module): 3.54 in. (90 mm)
– Front: 2.56 in. (65 mm)
Cisco IE 3000 Switch Hardware Installation Guide
2-26
Installing the Switch on a DIN Rail
Installing the Switch on the Wall
Installing the Switch in a Rack
Chapter 2 Switch Installation