Cisco IE 3000 Hardware Installation Manual page 164

Connecting the Switch to the Power Converter
Figure B-43
1 Ground
2 AC neutral
Tighten the ground wire terminal block screw.
Step 3
Note
Insert the line and neutral wire leads into the terminal block line and neutral connections. See
Step 4
Figure
from the connectors.
Tighten the line and neutral terminal block screws.
Step 5
Note
Replace the plastic cover over the terminal block.
Step 6
Connect the other end of the AC power cord to the AC outlet.
Step 7
Cisco IE 3000 Switch Hardware Installation Guide
B-58
Connecting AC Power to the Power Converter
1
2
3
3
The torque should not exceed 2.2 in-lb (0.25 Nm).
B-43. Make sure that you cannot see any wire lead. Ensure that only wire with insulation extends
The torque should not exceed 2.2 in-lb (0.25 Nm).
Appendix B
24V
Rtn Ou
t (-)
Pw r Ou
t (+)
DC OK
N /
L /
100 -24
0V~ , 50-
125 -25
0V
, 1.25 A
AC line
Installation In a Hazardous Environment
, 2.1 A
60H z/
MA X