Using System Functions From Outside Disa (Direct Inward System Access) - Siemens OpenStage 60T User Manual

More functions/services
Step by Step
126
Using system functions from outside
DISA (direct inward system access)
If configured (contact your service personnel), you can
use an external phone like an internal station to set up
an outgoing external connection via the system. You
can also activate or deactivate the following system
functions:
• Reset services and functions,
code #0 ! page 124
• Call forwarding, code
• Lock and unlock phone,
66/#66 ! page 114
code
*
• Save your PIN,
93 ! page 116
code
*
• Send a message,
68/#68 ! page 119
code
*
• Leave an advisory message,
69/#69 ! page 121
code
*
• Ringing group, code
• Group call, code
• Caller ID suppression,
86/#86 ! page 111
code
*
• Camp-on tone, code
• Open door, code
• Release door opener, code
• Control relays, code
• Do not disturb, code
• Ringer cutoff, code
• Dial using speed dial, code
• Associated service, code
Prerequisite: Your phone supports tone dialing (DTMF)
or you can switch your phone to tone dialing. The phone
is not connected to the system.
j
Establish a connection to the system. Enter the station
number (contact your service personnel).
j
Wait for the continuous tone (if necessary, switch
phone to tone dialing) and enter the internal number as-
signed to you and the corresponding PIN.
#
Enter the code (only required if programmed in the sys-
tem).
1/#1 ! page 83
*
81/#81 ! page 142
*
85/#85 ! page 142
*
87/#87 ! page 68
*
61 ! page 57
*
89/#89 ! page 58
*
90/#90 ! page 131
*
97/#97 ! page 111
*
98/#98 ! page 110
*
7 ! page 62
*
83 ! page 125
*