Using System Functions From Outside Disa (Direct Inward System Access) - Siemens HiPath 500 User Manual

Step by Step
Using system functions from outside
DISA (direct inward system access)
If configured (contact your service personnel), you can
use an external phone like an internal station to set up
an outgoing external connection via the system. You
can also activate or deactivate the following system
functions:
• Reset services and functions,
code #0
• Call forwarding, code
• Lock and unlock phone,
code 66/#66
*
• Save your PIN,
code 93
*
• Send a message,
code 68/#68
*
• Leave an advisory message,
code 69/#69
*
• Ringing group, code
• Group call, code
• Caller ID suppression,
code 86/#86
*
• Camp-on tone, code
• Open door, code
• Release door opener, code
• Control relays, code
• Do not disturb, code
• Ringer cutoff, code
• Dial using speed dial, code
• Associated service, code
Prerequisite: Your phone supports tone dialing (DTMF)
or you can switch your phone to tone dialing. The phone
is not connected to the system.
j
Establish a connection to the system. Enter the station
number (contact your service personnel).
j
Wait for the continuous tone (if necessary, switch
phone to tone dialing) and enter the internal number as-
signed to you and the corresponding PIN.
(
Enter the code (only required if programmed in the sys-
tem).
More functions/services
page 85
1/#1
*
page 75
page 76
page 79
page 81
81/#81
*
85/#85 page 102
*
page 73
87/#87
*
61 page 40
*
89/#89
*
90/#90
*
97/#97
*
98/#98
*
7
*
83
*
page 33
page 102
page 52
page 41
page 91
page 72
page 72
page 47
page 86
87