Electrical; Electrical Supply - Sirius Range Hoods SU1 Installation Instructions Manual

Maximum Run
6" or 8" 3 1/4 x 10" duct *
Deduct
Each 6" or 8" 90 elbow used
Each 6" or 8" 45 elbow used
Each 6" or 8" or 3 1/4 x 10" duct
Transition used
Each 3" 1/4 x 10" to 6" or 8"
Transition used
Side Wall with damper
Roof Cap
* Gas range or gas cook top recomman-
ded 8".
The ducting connection to the hood must
be in line with the central vertical axis of
the range hood 1" away from the back wall
on which the hood is to be mounted. The
1" is important to enable the ceiling bra-
cket (as shown in Figure 2) to pass behind
the ductwork servicing the range hood.
WARNING: All electrical work must be
performed by a qualified electrician.
Please ensure that the appropriate electri-
cal codes or prevailing local building co-
des and ordinances are adhered to.
Ensure that the electricity supply is di-
sconnected at source. Do not use an ex-
tension cord or adapter plug with this
appliance.
This appliance must be grounded. Con-
nect to a properly grounded branch cir-
cuit, protected by a 15 amp circuit bre-
aker.
100 FT
15FT
9FT
1FT
fig. 2
5FT
30FT
Range hoods may interrupt the proper
30FT
flow of combustion gases from fireplaces,
gas furnaces and gas water heaters.
To minimize the risk of drawing these lethal
gases back into the home, please follow the
heating equipment manufacturers safety
standards and guidelines carefully.
Refer to NFPA and ASHRAE for additional
information.
E LE CT RIC AL

Electrical Supply.

This range hood requires a 120V, 60Hz
supply and draws a maximum of 3 amps.
The electrical supply to the range hood
should be at least 17" from the underside
of the installed range hood.
For a typical installation, where the under-
side of the range hood will be 30" above
the counter top and the counter top is 36"
above the floor level, the electrical supply
should be 76" above floor level and no
further than 3" to the right (as you face
the wall) of the central axis of the range
hood.
5