Light Bulb Replacement; Substitution Of The Led Bar - Sirius Range Hoods SU1 Installation Instructions Manual

Light Bulb Replacement

(If in doubt, call 866.528.4987)
FOR SU202– SU 207 – SU 208
Turn blower and lights off. Make sure the
lights are cool.
If new lights do not operate, check fuses
and be sure globes and breakers are in-
serted correctly.
Do not remove the entire fixture (socket)
as this is very difficult to reinstall. Gently
pry the bulb from the fixture using a soft
instrument such as a toothpick. Steel in-
struments will scratch the surface (refer
to figure 18).
Replace the appropriate bulb. Check par-
ts brochure or specification sheets on
our website. Wipe both sides of the glass
whilst it is out. Reinsert the glass blo-
cking ring and fasten it.
fig. 19
FOR SU1 – SUE1 – SU3 – SUE3 – SU4 – SU5
– SUE5 – SU22 – SU26 – SU31 – SU47-P
Turn blower and lights off. Make sure the
lights are cool.
Do not remove the entire fixture (socket)
as this is very difficult to reinstall.
Visually inspect the light fixture and esta-
blish whether the unit has a smooth or
"toothed" metal ring.
If smooth remove the glass blocking ring
by prying out with a sharp, soft instru-
ment such as a toothpick (refer to figure
20).
fig. 20
Steel instruments will scratch the surface.
Be careful that the lens does not fall out.
If "toothed", place the tip of your finger
between the lens and the ring. Making
your way around the ring, gently pull
outwards until a point is found where the
ring pulls off.
Replace the appropriate bulb. Check
parts brochure or specification sheets on
our website. Wipe both sides of the glass
whilst it is out.
FOR SU92 - SU97

Substitution of the LED bar:

Using an appropriate tool, remove the
LED bar from its seat (refer to Fig. 21),
disconnect it electronically using the ap-
propriate connector then substitute it
with a LED bar with same characteristics.
fig. 21
15