Copy Of Safety Decal - Regency Horizon HZ40E Owners And Installation Manual

This is a copy of the label that accompanies each HZ40E-NG10 and HZ40E-LP10 Direct Vent Gas Fireplace. We have printed a copy of the contents here
for your review.
units are constantly being improved. Check the label on the unit and if there is a diference, the label on the unit is the correct one.
®
NOTE: Regency
Listed: VENTED GAS FIREPLACE HEATER / FOYER AU GAZ À ÉVACUATION
Certified for/Certifi e pour:
Tested to: CAN/CGA-2.17-M91(R2009)
Conforms to:
Certified to:
CSA 2.33-20
4001172 MAY BE INSTALLED IN MANUFACTURED (MOBILE) HOMES AFTER FIRST SALE.
NATURAL GAS: Model HZ40E-NG10
Minimum supply pressure
5.0"
Manifold pressure 3.5"
Orifice size
# 0 4
Maximum input
26
Minimum input 18
Altitude
0-4500
PROPANE GAS: Model HZ40E-LP10
Minimum supply pressure
11
Manifold pressure
10"
Orifice size # 5
Maximum input
25 5
M imum input in
21
Altitude 0-4500
This appliance must be installed in accordance with local codes, if any; if none, follow the National Fuel Gas Code, ANSI Z223.1, or Natural Gas and Propane Installation Code, CSA B149.1.
This appliance must be installed in accordance with the Standard CAN/CSA Z240 MH, Mobile Housing, in Canada, or with the Manufactured Home Construction and Safety Standard, Title 24 CFR, Part 3280, in the
United States, or when such a standard is not applicable, ANSI/NCSBCS A225.1/NFPA 501A, Manufactured Home Installations Standard or ANSI A119.2 ou NFPA 501C Standard for Recreational Vehicles
This appliance is only for use with the type of gas indicated on the rating plate and may be installed in an aftermarket, permanently located, manufactured (mobile) home where not prohibited by local codes. See
owner's manual for details. This appliance is not convertible for use with other gases, unless a certified kit is used.
Installer l'appareil selon les codes ou règlements locaux, ou, en l'absence de tels règlements, selon les codes d'installation ANSI Z223.1, National Fuel Gas Code ou CSA-B149.1 en vigueur.
Installer l'appareil selon la norme CAN/CSA-Z240, Série MM, Maison mobiles ou CAN/CSA-Z240 VC, Véhicules de camping, ou la norme 24 CFR Part 3280, Manufactured Home Construction and Safety
Standard. Si ces normes ne sont pas pertinentes, utilisez la norme ANSI/NCSBCS A225.1/NFPA 501A, Manufactured Home Installations Standard, ou ANSI A119.2 ou NFPA 501C Standard for Recreational
Vehicles.
Cet appareil doit être utili sé uniquement avec le type de gaz indiqué sur la plaque signalétique. Cet appareil peut être installé dans une maison préfabriquée ou mobile (É.-U. seulement) installée à demeure si les
règlements locaux le permettent. Voir la notice de l'utilisateur pour plus de renseignements. Cet appareil n'est pas convertible pour une utilisation avec d'autres gaz, sauf si une trousse certifié est utilisé .
This vented gas fireplace heater is not for use with air filters.
FOR USE WITH GLASS DOORS CERTIFIED WITH THE APPLIANCE ONLY
For Use Only with Barrier (Part #
Fan (Part # 258 -917) /Ventilateur (pièce n°258-917)
Electrical supply / Alimentation é lectrique 115VAC, 1.13 A, 60Hz.
NOT FOR USE WITH SOLID FUELS. / NE PAS UTILISER AVEC
For the State of Massachusetts, installation
and repair must be done by a plumber or
gasitter licensed in the Commonwealth of
Massachusetts.
For the State of Massachusetts, lexible con-
nectors shall not exceed 36 inches in length.
For the State of Massachusetts, the appli-
ances individual manual shut-of must be a
t-handle type valve.
The State of Massachusetts requires the
installation of a carbon monoxide alarm in
accordance with NFPA 720 and a CO alarm
with battery back up in the same room where
the gas appliance is installed.

COPY OF SAFETY DECAL

é
CANADA and U.S.A.
ANSI Z21.88-2014
14
APPAREIL FONCTIONNANT AU G
Mod le HZ40E-NG è
Pression d'alimentation minimum
WC/C.E. (1.25kPa)
WC/C.E. (0.87kPa) Pression de sortie (manifold)
Taille de l orifice
DMS
D bit alorifique maximum é c
,000 Btu/h ( 7.61 kW)
,000 Btu/h ( 5.28 kW) D bit alorifique minimum selon é c
l'altitude
ft/pi (0-1372 m)
APPAREIL FONCTIONNANT AU GAZ PROPANE
Mod le HZ40E-LP è
WC (2.73 kpa)
Pression d'alimentation minimum
WC/C.E. (2.49kPa)
Pression de sortie (manifold)
3 DMS
Taille de l orifice
, 00 Btu/h ( 7.47 kW)
D bit alorifique maximum é c
,000 Btu/h ( 6.15 kW)
D bit alorifique minimum selon é c
ft/pi (0-1372 m)
l'altitude
258 013 Follow installation instructions. - )
UN
Duplicate S/N
DO NOT REMOVE THIS LABEL / NE PAS ENLEVER CETTE ÉTIQUETTE
AZ NATUR L E
10
et
10
et
Ne pas utiliser de filtre à air avec ce foyer au gaz à évacuation.
DOIT ÊTRE UTILIS UNIQUEMENT AVEC LES PORTES É
Utiliser uniquement avec un écran de protection (n°258 013). Suivre les consignes d'installation.
FPI Fireplace Products International Ltd. Delta, BC, Canada
COMBUSTIBLE SOLIDE.
safety decal
412
Serial No./ No de s rie
412
Minimum Clearances to Combustibles /
D gagement é s m inim aux d s m é e at riaux ombustibles c
Side Walls/Murs latéraux
A 8 (203mm)
Ceiling/Plafond
B
B 22
D
F
Min. Mantel Height/Hteur min. manteau
C 17
A
C Max. Mantel Depth/Prof. max. manteau
D 1
Alcove Width/Largeur alcôve
E 84
E
Alcove Depth/Prof. alcôve
F 36" (
DOOR SEAL: Please
check that the door is
(See Instruction Manual for
properly sealed detailed instructions)
VITRÉES CERTIFIÉES AVEC L'APPAREIL
-
Made in Canada/ Fabriqu au Canada é
Regency Horizon ® HZ40E-10 Gas Fireplace
|
5
é
( 559 mm)
" ( 432 mm)
3 ( 330 mm)
" (1524mm)
2134 mm)
e e
919-361
| 5