Chapter 7 - Commissioning; Introduction; First Time Switch On - Honeywell Touchpoint Plus Technical Handbook

Hide thumbs Also See for Touchpoint Plus:

Table of Contents

MAN0984_Iss 2_06/15

Chapter 7 – Commissioning

This chapter explains several tasks that may be required during commissioning.

First time switch-on and Commissioning should only be carried out by a Honeywell engineer or someone with

System Administrator privileges who has been trained in accordance with this manual.

During First Time Switch On, it will be necessary to confirm or set the Date, Time and Language, to set new

passwords and delete the default password, and to program passwords tasks.

If the system was ordered from Honeywell Analytics, carry out Ch.7.5 Commission Input / Output Modules and

Ch.7.6 Channel Configuration for the input channels before proceeding with Ch.7.6 Channel Configuration for

the Relay Output channels and the mA Output channel.

Before switching power on, ensure that a qualified person has checked that the wiring is safe and conforms to

local regulations, and that all electrical connections are in accordance with Section 4. Also check that the

battery isolator switches are 'On' if a backup battery is fitted.

Switch on power. You can use a multi-meter to check that the DC supply to the DC Connector block is

between 18 and 32 VDC (≥24 VDC when a battery is installed).

The system start up sequence may last for up to 5 minutes depending on the number of channels in use.

When start up is completed, Touchpoint Plus will display the Input screen, indicating the current status of the

system. The Channel list view is shown below:

Key to Icons:

Commissioning

Toggle to select screen layout

External mains power is provided.

Touch for status

External power is not connected.

Touch for status

Event History (Inhibit shown)

Toggle auto-scroll on and off

Filter Display (Inhibits shown)

Touchpoint Plus

Technical Handbook

Table of Contents

Chapters

Table of Contents