Table of Contents
Advertisement
ENGINEERING, COMMISSIONING
Required Preparations
In order to access (with a laptop or PC) the EAGLEHAWK
controller via Ethernet/IP for the first time, you may employ
any one of the following two options:
Option 1: USB 2.0 Device (recommended)
This USB 2.0 Device interface is the recommended interface
for downloading applications and firmware via COACH
"A-Male to B-Male" USB cable is required.
Fig. 24. A-male to B-male USB cable
For access via USB, the EAGLEHAWK controller has a
permanent default IP address 192.168.255.241. Your PC's IP
address must match the EAGLEHAWK controller's default IP
address subnet: We recommend using DHCP or "Obtain an
automatic IP address".
EAGLEHAWK CONTROLLER – INSTALLATION & COMMISSIONING INSTRUCTIONS
AX
. An
Option 2: Standard Ethernet Interface
The standard IP address can be set in COACH
purpose, connect first with the USB interface. In any case,
your PC's IP address must match the EAGLEHAWK
controller's default IP address subnet. We recommend using
DHCP or "Obtain an automatic IP address".
Behavior of Outputs during Download
Table 11. Behavior of outputs during firmware download /
application download
output behavior during
analog, binary, and
firmware / Linux
floating outputs
As soon as "receive
heartbeat" (the value
outputs of Panel
of which CANNOT be
I/O modules
(CLIOP82x)
COACH
outputs go to safety
As soon as "receive
heartbeat" (the value
outputs of
of which can be
L
W
I/O
ON
ORKS
modules
COACH
(CLIOL82x)
outputs go to safety
NOTE: These behaviors were determined using a test
application with a cycle time of 10 seconds. A value
update was triggered every 10 seconds.
13
AX
. For this
output behavior
during application
download
download
Outputs remain in
altered using
the previous
AX
) expires,
position / state
position.
Outputs remain in
altered using
the previous
AX
) expires,
position / state.
position.
EN1Z-1005GE51 R0216
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
