Viewing Output Channels; Viewing Th E Trend Graph - Honeywell Touchpoint Plus Technical Handbook

MAN0984_Iss 2_06/15

6.11 Viewing Output Channels

From the Input screen, toggle the Home icon
Output.
1) From the Input screen, select Channel List or Channel Tile.
2) A list of all output channels is shown in order of channel ID. The channel ID, location tag and status are
shown.
3) The list can be filtered by status – Fault, Inhibit, Warning or All.
4) Select a channel and the Channel detail screen will appear. Depending on access level, a number of
options will be shown:
Function
Linked input Channel Nr.
Channel configuration

6.12 Viewing th e Trend Graph

The Trend graph is drawn using one minute average readings so it is not suited to viewing short-term signal
fluctuations.
To view the graph:
1) Select the Menu>Information>Trend/Plot.
2) Select the required channel, and then select Data range.
3) The trend graph will be displayed.
Note: Touchpoint Plus trend graph will retain the latest 8 hours of data but will be cleared after a power reset.
Note: Touchpoint Plus does not adjust automatically for daylight savings time so Touchpoint Plus will retain a
backup of the earlier data if the clock is backdated (i.e. when ending daylight savings time).
Operating Instructions
Access Level Comment
Viewer Display an input channel number that is mapped to the output channel
Change the output channel configurations: Inhibit, Fault, Warning, and
Engineer
Over-range output level
between Channel Tile>Channel Summary>Channel
49
Touchpoint Plus
Technical Handbook