Pulse Input - GE PQMII Instruction Manual

CHAPTER 5: SETPOINTS
5.3.6

Pulse Input

PULSE INPUT
PQMII POWER QUALITY METER – INSTRUCTION MANUAL
Normally Open (NO) Contact
Normally Closed (NC) Contact
PATH: SETPOINTS S2 SYSTEM SETUP
[ ] PULSE INPUT
UNITS:
PULSE INPUT 1 VALUE:
MESSAGE
1 Units
PULSE INPUT 2 VALUE:
MESSAGE
1 Units
PULSE INPUT 3 VALUE:
MESSAGE
1 Units
PULSE INPUT 4 VALUE:
MESSAGE
1 Units
PULSE INPUT TOTAL:
MESSAGE
1+2+3+4
• PULSE INPUT UNITS: This message allows the user to input a user defined 10
character alphanumeric unit for the pulse inputs (i.e. kWh). The unit will be used by all
pulse inputs including the totalized value. To enter the unit, perform the following
steps:
Allow access to setpoints by enabling setpoint access.
Select the
Use the
space is selected like a character.
Press the
next position. To skip over a character press the
STATUS
OPEN
CLOSED
FIGURE 5–2: Pulse Output Timing
PULSE INPUT
Units
setpoint.
PULSE INPUT UNITS
keys to change the blinking character over the cursor. A
VALUE
key to store the character and advance the cursor to the
ENTER
STATUS
STATUS
CLOSED
OPEN
CLOSED
OPEN
PULSE
WIDTH
Range: 10 alphanumeric characters
Range: 0 to 65000 in steps of 1
Range: 0 to 65000 in steps of 1
Range: 0 to 65000 in steps of 1
Range: 0 to 65000 in steps of 1
Range: 1+2, 1+3, 1+4, 2+3, 2+4, 3+4,
1+2+3, 1+3+4, 1+2+4, 2+3+4,
1+2+3+4
key.
ENTER
5–29