6.3.2
Switch Status
SWITCHES
6–20
MESSAGE
MESSAGE
MESSAGE
MESSAGE
MESSAGE
MESSAGE
MESSAGE
MESSAGE
MESSAGE
MESSAGE
MESSAGE
The alarm messages appear only when the alarm threshold has been exceeded for the
programmed time. When an alarm is assigned to an output relay, the relay can be set to be
unlatched or latched. When the alarm is set as unlatched, it automatically resets when the
alarm condition no longer exists. If the alarm is set as latched, a keypad reset or a serial
port reset is required.
The
occurs if a fault in the PQMII hardware is detected. This alarm is
SELF TEST ALARM
permanently assigned to the alarm output relay and is not user configurable. If this alarm
is present, contact the GE Multilin Service Department.
PATH: ACTUAL VALUES
A2 STATUS
[ ]
MESSAGE
MESSAGE
MESSAGE
MAIN ANALOG INPUT
ALARM
ALT ANALOG INPUT
ALARM
CRITICAL SETPOINTS
NOT STORED
CURRENT THD
ALARM
VOLTAGE THD
ALARM
PULSE INPUT 1
ALARM
PULSE INPUT 2
ALARM
PULSE INPUT 3
ALARM
PULSE INPUT 4
ALARM
TOTALIZED PULSES
ALARM
TIME
ALARM
SWITCHES
SWITCH INPUT A
STATE: Closed
SWITCH INPUT B
STATE: Closed
SWITCH INPUT C
STATE: Closed
SWITCH INPUT D
STATE: Closed
PQMII POWER QUALITY METER – INSTRUCTION MANUAL
CHAPTER 6: MONITORING