Connecting The Power Supply - Pro-face GP-4201TM Hardware Manual

Connecting the Power Supply

Precautions
60
Connect the power cord to the power connector on the side of the unit using the

DC power supply connector.
Use a regulated power supply with a Class 2 power supply between the line and

the ground.
Do not bundle the power supply cord with, or keep close to, main circuit lines

(high voltage, high current), or input/output signal lines.
Connect a lightning surge absorber to handle power surges.

Excessive stress on the power connection or attempting to install a unit with the
power cables connected may disconnect or cause damage to the power
connections. This can cause short circuits, fire or unintended equipment operation.
SHORT CIRCUITS, FIRE, OR UNINTENDED EQUIPMENT OPERATION
Securely attach power cables to the panel or cabinet.

Use the designated torque to tighten the unit terminal block screws.

Install and fasten unit on installation panel or cabinet prior to connecting Power

Supply and Communication lines.
Failure to follow these instructions can result in death, serious injury, or
equipment damage.
GP-4201TM/4301TM/4000M Hardware Manual
WARNING