Power Connection - Pro-face GP-4201TM Hardware Manual

Installation and Wiring
How to connect the Power Cord

Power Connection

The following table explains how to connect the DC power supply connector:
Step Action
1 Remove the power cord from the power supply.
2 Remove the DC power supply connector from the unit.
3
Remove 7 mm (0.28 in) of the vinyl cover of each of the power cord wires.
4 If using stranded wire, twist the ends. Tinning the ends with solder reduces the risk of
fraying and enhances electrical transfer.
5 Connect the wires to the DC power supply connector by using a flat-blade screwdriver
(Size 0.6 x 3.5).
6 Torque the mounting screws: 0.5 to 0.6 N•m (4.4 to 5.2 lb-in).
7 Replace the DC power supply connector to the power connector on the side of the
unit.
NOTE:
Do not solder the wire directly to the power receptable pin.

The power supply cord must meet the specification shown above. Twist the

power cords together, up to the DC power supply connector, for EMC
cancellation. (See illustration as shown below).
The following illustration displays a connection of the power cord:
59