Table of Contents
Advertisement
9150
User's Guide
8.4.4
Program Function Mode
The next parameter is the program function or cycle mode. There are four
possible modes which determine whether the program scans up (from set-point 1
to n) only or both up and down (from set-point n to 1), and also whether the
program stops after one cycle or repeats the cycle indefinitely. The table below
shows the action of each of the four program mode settings.
Function
1
2
3
4
=
Press "SET" to adjust the program mode and the "UP" or "DOWN" buttons to
change the mode.
=
Press "SET" to continue or "EXIT" to continue without saving the new value.
8.4.5
Program Control
The final parameter in the program menu is the control parameter. You may
choose between three options to either start the program from the beginning,
continue the program from where it was when it was stopped, or stop the
program.
=
Use the "UP" or "DOWN" buttons to change the status.
=
Press "SET" to activate the new program control command and return to the
temperature display.
8-8
Find Quality Products Online at:
Action
up-stop
up-down-stop
up-repeat
up-down-repeat
Program mode
New mode
Save new setting
Program presently off
Start cycle from beginning
Activate new command.
GlobalTestSupply
www.
.com
sales@GlobalTestSupply.com
Hide quick links:
Advertisement
Table of Contents
