burroughs smartsource series Installation And Operation Manual page 50

Cleaning the Unit
3. Wipe any ink that may be present off the cartridge contacts inside the cartridge
housing.
4. Wipe any ink that may be present off the window inside the cartridge housing.
5. Dampen a clean, lint-free cloth with a small amount of water.
Note: The cloth should not be too wet, as water must not drip or remain on the unit.
Do not use alcohol to wipe the cartridge nozzles. This will cause damage.
Do not use the Image Glass Cleaning Pads from Burroughs
(75-1804-907) to wipe the cartridge nozzles. These pads are pre-saturated
with isopropyl alcohol that will cause damage to the cartridge.
6. Hold the cloth gently against the cartridge nozzles for three seconds. Then, wipe the
nozzles in one direction only, UP, as shown here.
3-16
Caution
4326 9562-007