Phone Call - Audison bit one Advanced Manual

DRC - Digital Remote Control

PHONE CALL

The PHONE input can't be selected as normal source
because it activates exclusively when an external handsfree
telephone sends the MUTE when receiving a phone call. The
DRC display will show the message shown on the right, the
Bit One will set the source selected in that moment to muting,
reproducing the signal coming from the PHONE input.
During the phone call the volume can be adjusted through
the DRC knob.
Please, note that in any case you can pre-set the volume
of this "source" and customize an adequate equalization
curve through the software.
SEL BUTTON FUNCTIONS
By pressing the SEL button you can access:
*1 Dual Power Memory: this entry is active only if amplifiers
featuring Dual Power and Bias Control (Thesis TH) are
connected to the Bit One. You can recall the pre-sets
set in each amplifier.
- DSP Memory: the A/B/C/D set memories can be recalled
(through the software) and stored in the processor (Bit One);
- DSP Settings: through this menu you can enable/
disable the Dynamic EQ as well as the Auto IN Level Adj.
Function;
- Auto IN Level Adj: if while listening to the music the
MASTER source volume moves and you don't have any
indications about its original level, to correctly set it back
to the level it was when it was initially tuned, insert the
"Installation CD" into the head unit, play track 1 and press
the "yes" button on the DRC. Now adjust the MASTER
source volume until the cursor (+) is on "0" and not over
(to avoid the clipping).
- Brightness: to adapt the DRC to the light conditions
inside the car compartment you can adjust the display
and the red switch bezel brightness.
*2 This entry is only active
if amplifiers featuring
the Amplifier Status
Controller are connected
to the Bit One through
the AD Link / AC Link
connection system.

42 42
ADVANCED MANUAL / Bit One ADVANCED MANUAL / Bit One






