Main Menu : File - Audison bit one Advanced Manual

12. MAIN MENU: FILE
Clicking on the corresponding button a drop-down menu
opens up listing the following entries:
- Load Setup..: it loads the Bit One entire Setup from a
previously saved file (.bit format)
- Save Setup..: it saves the Bit One entire Setup in a file that
can be recalled (.bit format)
- FINALIZE to Bit One: it loads all the parameters set during
the tuning process (as well as the four memories) into
the Bit One microprocessor internal memory.
WARNING:
always perform this operation before
disconnecting the Bit One from the PC.
- Synchronize: PC to Bit One or Bit One to PC: it
synchronizes and transfers the software data from PC to
the Bit One or vice versa.
WARNING:
this operation is very useful in case the
communication between the two devices gets
interrupted for some reason.
- Check for Updates: it checks if any update on the software
or on the microprocessor firmware is present.
WARNING: internet connection is required to properly
perform this operation.
- Update Firmware: it updates the firmware if it has been
detected during the Check for Updates process and if
its corresponding file (.bin format) was saved in the PC.
(see RESCUE MODE page 36)
- Reset Default Answer: it restores the display of the
warning messages that have been possibly disabled
while using the software.
- Restore Factory Defaults: it resets the Bit One back to its
default settings.
- Restore Factory Defaults: it totally resets the Bit One.
WARNING:
by performing this operation all the data
previously saved in the Bit One are cancelled!
- Credits: it shows the information about the Bit One
software.
- Exit: it exits the program.
When running the FINALIZE to Bit One, the software notifies
that the data entered in the Bit One will be overwritten.
The Bit One software can now be shut down and the Bit
One can work autonomously.
ADVANCED MANUAL / Bit One ADVANCED MANUAL / Bit One
36 36