Troubleshooting - Audison bit one Advanced Manual

TROUBLESHOOTING

- If, while tuning the system with a laptop PC connected to the Bit One, the device shows some functioning problems,
try to disconnect the laptop PC power supply cable. This way, with the laptop PC working on battery power, you avoid
a possible voltage difference in USB ground connection between car ground (Bit One) and earth (PC).
- If, while tuning the system with the PC connected to the Bit One, the device is switched off and then on again, the
connection is lost and the sotfware can not "finalize" the selected setup. If you don't want to lose the modifications
and setup previously selected, proceed as per the following steps:
a- save the setup as a file on the PC using the function: FILE / SAVE SETUP;
b- switch off the software;
c- turn on the Bit One;
d- launch the software again;
e- load again the setup file using the function: FILE / LOAD SETUP .
- If, while tuning the system with the PC connected to the Bit One, the device does not respond, proceed as per the
following steps:
a- turn the Bit One off:
- pushing the DRC knob, or
- disconnecting the Remote IN, or
- disconnecting the power supply cable for few seconds;
b- save the setup as a file on the PC using the function: FILE / SAVE SETUP;
c- switch off the software;
d- turn on the Bit One;
e- launch the software again;
f- load again the setup file using the function: FILE / LOAD SETUP .
- In order to successfully complete the Bit One set up phase and not to lose the work done, remember to store the
selected settings. Select "File" from the management software menu via the PC and then choose "Finalize to Bit One".
RESCUE MODE
If, when launching the Bit One PC software the following
Warning window appears, you can choose between the
following two ways to proceed:
1- Use a previous version of the PC software. Example: if
you are using the PC software v. 1.5, open the v.1.3;
2- Update the Bit One Firmware.
In this second case you will have to proceed as follows:
- Save the previously set setup (in case you want to open
it in OFF LINE mode);
- Press OK on the Warning window;
- Restart the Bit One PC software and select the RESCUE
MODE;
- The first screen will show the Firmware version currently
installed in the Bit One providing the ability to access to
the menu / the update functions;
ADVANCED MANUAL / Bit One ADVANCED MANUAL / Bit One
37 37