Audison bit one Advanced Manual page 33

The semi-automatic procedure goes on
requesting to set the reference listening
volume level to high. Set the Volume
cursor adjusting it at the desired level.
Once you have adjusted the cursor,
press the START button.
Move the EQ cursor to tune the
equalization of the high volume response
until you get the desired sound. Once you
have found the right adjustment press the
SAVE button.
Now the reference curve for a high
volume listening level has been entered.
To confirm the adjustments and enable
the Dynamic Equalizer while listening to
the music click on the X.
Reset Dynamic EQ
While adjusting the system, you can
press the Reset Dyn. EQ button to check
in real time the modifications the Dynamic
Equalization applied to the signal.
If you press that same button again,
the set up procedure resumes from the
point it was interrupted.
ADVANCED MODE
In this mode the equalization curve is
not fixed but it can be selected through
a 31-band graphic equalizer.
The steps to adjust it are exactly the
same as those described so far, adding
to them the possibility of operating with
a custom curve.
Just for example on your right you can
see the main screenshot showing a
"custom" equalization.
The result of the Dynamic Equalization
is automatically stored in the main
set up. During regular reproduction
the Dynamic EQ can be disabled
by selecting the specific entry from
the main menu Config/Dynamic
Equalization / On.
ADVANCED MANUAL / Bit One ADVANCED MANUAL / Bit One
33 33