Atis Setup; Atis Code Programming - Standard Horizon QUANTUM GX6500E Owner's Manual

21 ATIS SETUP

The GX6500E/GX6000E supports the ATIS (Automatic Transmitter Identifica-
tion System) used in Inland waterways in Europe. When enabled ATIS mode
transmits a unique ATIS code each time the PTT switch is released at the end
of a transmission.
Users should check with their local marine regulatory authority in their country
for assistance in obtaining an ATIS code.
21.1

ATIS CODE PROGRAMMING

1. Press the MENU key to display "MENU".
2. Rotate the DIAL/ENT knob to select
"SETUP", then press the [SELECT] soft key.
3. Rotate the DIAL/ENT knob to select "ATIS
SETUP", then press the [SELECT] soft key.
4. Rotate the DIAL/ENT knob to select "ATIS
CODE", then press the [SELECT] soft key.
5. Rotate the DIAL/ENT knob to select the
first number of your ATIS, then press the
[SELECT] soft key to step to the next
number.
6. Repeat step 5 to set your ATIS (ten digits).
7. If a mistake was made entering in the ATIS,
Rotate the DIAL/ENT knob to select "<-" or
"->", press the [SELECT] soft key until the
wrong number is selected, then perform step
5.
8. When finished programming the number,
press the [FINISH] soft key. The Radio will
ask you to input the ATIS number again.
Perform steps 5 through 7 above.
9. After the second number has been input,
press the [FINISH] soft key to store the ATIS
number in memory.
10. Press the [OK] soft key to return to radio operation.
Page 184 GX6500E/GX6000E