Table of Contents
Advertisement
Installation & Basic Configuration
Download Updates from your TFTP Server using the CLI Interface
1. Download the latest software from http://www.proxim.com.
2. Copy the latest software updates to your TFTP server.
3. Open the CLI interface via Telnet or a serial connection.
4. Enter the CLI password when prompted.
5. Type set tftpfilename <file name> (include the file extension) and press Enter.
6. Type set tftpfiletype img and press Enter.
7. Type set tftpipaddr <IP address of your TFTP server> and press Enter.
8. Type show tftp and confirm that the file name, file type, and IP address are correct.
9. Type download * and press Enter.
–
Result: The download will begin. Be patient while the image is downloaded to the Access Point.
10. When the download is complete, type reboot 0 and press Enter.
NOTE
See
Command Line Interface (CLI)
Additional Hardware Features
•
Mounting Options
•
Kensington Security Slot
•
LED Indicators
Mounting Options
There are three mounting options for the AP-600, described below. If you intend to install the unit in a plenum, see
Installing the AP-600 in a
Desktop Mount
This is the standard installation for the AP-600. See
Wall Mount
Follow these steps to mount the AP-600 on a wall:
1. Identify the location where you intend to mount the unit.
NOTE
For best results, mount the unit vertically. In other words, the antenna should be pointing up or down but not
sideways.
2. Unplug the Access Point's power supply, if necessary.
3. Use a Phillips screwdriver to remove the metal base from the underside of the AP-600, if necessary.
4. Press down on the cable cover lock to release the cable cover. See
5. Remove the cable cover from the unit. See
6. Remove the front cover from the unit. See
7. Remove the back cover from the unit. See
8. Place the back cover on the mounting location and mark the center of the three mounting holes.
9. Remove the cover from the wall and drill a hole at each of the locations you marked above. Each hole should be
wide enough to hold a mounting plug (which is 6 mm x 35 mm).
10. Insert a plug into each hole. The AP-600 comes with four 6 mm x 35 mm plugs; you only need to use three of these
when wall mounting the unit.
11. Insert a screw into each of the mounting holes molded into the back cover. The AP-600 comes with four 3.5 mm x
40 mm pan-head screws; you only need to use three of these when wall mounting the unit.
for more information.
Plenum.
Installation
Remove Cable Cover
Remove the Front Cover
Remove the Back Cover
for instructions.
Unlock the Cable Cover
for an illustration.
for an illustration.
for an illustration.
for an illustration.
30
Advertisement
Table of Contents
