Table of Contents
Advertisement
ORiNOCO AP-600 User Guide
Commands
In This Chapter
This chapter describes the commands that can be issued from the Access Point's HTTP interface.
•
Logging into the HTTP Interface
•
Download:
Download files from a TFTP server to the AP-600.
•
Upload:
Upload configuration files from the AP-600 to a TFTP server.
•
Reboot:
Reboot the AP-600 in the specified number of seconds.
•
Reset:
Reset all of the Access Point's configuration settings to factory defaults.
•
Help Link:
Configure the location where the AP-600 Help files can be found.
Logging into the HTTP Interface
Once the AP-600 has a valid IP Address and an Ethernet connection, you may use your web browser to issue
commands.
The Command Line Interface (CLI) also provides a method for issuing commands using Telnet or a serial connection.
This section covers only use of the HTTP Interface. For more information about issuing commands with the CLI, refer
to
Command Line Interface
Follow these steps to view the available commands supported by the AP-600's HTTP interface:
1. Open a Web browser on a network computer.
NOTE
The HTTP interface supports the following Web browser:
•
Microsoft Internet Explorer 5.5 or later
•
Netscape 4.x or later
2. If necessary, disable the Internet proxy settings. For Internet Explorer users, follow these steps:
–
Select Tools > Internet Options....
–
Click the Connections tab.
–
Click LAN Settings....
–
If necessary, remove the check mark from the Use a proxy server box.
–
Click OK twice to save your changes and return to Internet Explorer.
3. Enter the Access Point's IP address in the browser's Address field and press Enter.
–
Result: The Enter Network Password screen appears.
4. Enter the HTTP password in the Password field and click OK. Leave the User Name field blank. (By default, the
HTTP password is "public").
–
Result: The System Status screen appears.
(CLI).
6
81
Advertisement
Table of Contents
