Table of Contents
Advertisement
Advanced Configuration
Management
The Management category contains three sub-categories.
–
Passwords
–
IP Access Table
–
Services
Passwords
You can configure the following passwords:
•
SNMP Read Password: The password for read access to the AP-600 using SNMP. Enter a password in both the
Password field and the Confirm field. The default password is "public".
•
SNMP Read/Write Password: The password for read and write access to the AP-600 using SNMP. Enter a
password in both the Password field and the Confirm field. The default password is "public".
•
Telnet (CLI) Password: The password for the CLI interface (via serial or Telnet). Enter a password in both the
Password field and the Confirm field. The default password is "public".
•
HTTP (Web) Password: The password for the Web browser HTTP interface. Enter a password in both the
Password field and the Confirm field. The default password is "public".
NOTE
For security purposes Proxim recommends changing ALL PASSWORDS from the default "public"
immediately, to restrict access to your network devices to authorized personnel. If you lose or forget your
password settings, you can always perform the
IP Access Table
The Management IP Access table limits in-band management access to the IP addresses or range of IP addresses
specified in the table. This feature applies to all management options (SNMP, HTTP, and CLI) except for CLI
management over the serial port. To configure this table, click Add and set the following parameters:
•
IP Address: Enter the IP Address for the management station.
•
IP Mask: Enter a mask that will act as a filter to limit access to a range of IP Addresses based on the IP Address
you already entered.
–
The IP mask 255.255.255.255 would authorize the single station defined by the IP Address to configure the
Access Point. The AP-600 would ignore commands from any other IP address. In contrast, the IP mask
255.255.255.0 would allow any device that shares the first three octets of the IP address to configure the
AP-600. For example, if you enter an IP address of 10.20.30.1 with a 255.255.255.0 subnet mask, any IP
address between 10.20.30.1 and 10.20.30.254 will have access to the AP's management interfaces.
•
Comment: Enter an optional comment, such as the station name.
To edit or delete an entry, click Edit. Edit the information, or select Enable, Disable, or Delete from the Status
pull-down menu.
Reset to Factory Default
Procedure.
52
Advertisement
Table of Contents
