Table of Contents
Advertisement
Installation & Basic Configuration
Figure 2-9
Scan Tool Change Screen
3.
Set IP Address Type to Static.
4.
Enter a static IP Address for the AP-600 in the field provided. You must assign the unit a unique address
that is valid on your IP subnet. Contact your network administrator if you need assistance selecting an IP
address for the unit.
5.
Enter your network's Subnet Mask in the field provided.
6.
Enter your network's Gateway IP Address in the field provided.
7.
Enter the SNMP Read/Write password in the Read/Write Password field (for new units, the default
SNMP Read/Write password is "public").
NOTE
The TFTP Server IP Address and Image File Name fields are only available if ScanTool detects that the
AP-600 does not have a valid software image installed. See
8.
Click OK to save your changes.
— Result: The Access Point will reboot automatically and any changes you made will take effect.
9.
When prompted, click OK a second time to return to the Scan List screen.
10. Click Cancel to close the ScanTool.
11. Proceed to
Setup Wizard
for information on how to access the HTTP interface.
Client Connection
Problems.
25
Advertisement
Table of Contents
