Table of Contents
Advertisement
Advanced Configuration
Services
You can configure the following management services:
NOTE
You must reboot the Access Point if you change the HTTP Port or Telnet Port.
SNMP Settings
•
SNMP Interface Bitmask: Configure the interface or interfaces (Ethernet, Wireless, All Interfaces) from which
you will manage the AP-600 via SNMP. You can also select Disabled to prevent a user from accessing the AP-600
device via SNMP.
HTTP Access
•
HTTP Interface Bitmap: Configure the interface or interfaces (Ethernet, Wireless, All Interfaces) from which you
will manage the AP-600 via the Web interface. For example, to allow Web configuration via the Ethernet network
only, set HTTP Interface Bitmask to Ethernet. You can also select Disabled to prevent a user from accessing the
AP-600 from the Web interface.
•
HTTP Port: Configure the HTTP port from which you will manage the AP-600 via the Web interface. By default, the
HTTP port is 80.
Figure 4-11
Management Services Configuration Screen
53
Advertisement
Table of Contents
