Table of Contents
Advertisement
Command Line Interface (CLI)
Configure 802.1x Authentication
[Device Name]>set secconfig <none, 802.1x, mixed>
[Device Name]>set secenckeylentbl 3 enckeylen <64bits, 128bits>
[Device Name]>set secrekeyint <60 – 65535 seconds; default is 900 sec>
[Device Name]>reboot 0
NOTE
If you set Security to 802.1x or Mixed, you also need to configure the RADIUS parameters. If you set Security
to Mixed, you also need to configure WEP Encryption settings. See
Set RADIUS Parameters
Configure RADIUS Authentication server
[Device Name]>set radiustbl <index> status enable seraddrfmt <ipaddr or name>
ipaddr <RADIUS IP address or name> port <user defined>
ssecret <user defined> responsetm <1 to 4 seconds>
maxretx <1 to 10 times>
[Device Name]>show radiustbl
Figure A-17 Results of "show radiustbl" CLI command
Enable RADIUS MAC Access Control
[Device Name]>set radmacaccctrl enable
[Device Name]>reboot 0
Set MAC Address Format Type
[Device Name]>set radmacaddrformat <dashdelimited, colondelimited, singledashdelimited,
nodelimiter>
Set Authorization Lifetime
[Device Name]>set radauthlifetm <900-43200 seconds; default is 900>
Enable RADIUS Accounting
[Device Name]>set radaccstatus enable
[Device Name]>set radaccinactivetmr <inactivity timer in minutes>
[Device Name]>show radius
802.1x
for details.
116
Advertisement
Table of Contents
