Alarms Parameters; Snmp Table Host Table Parameters; Syslog Parameters - ORiNOCO AP-600 User Manual

Command Line Interface (CLI)

Alarms Parameters

SNMP Table Host Table Parameters

When creating table entries, you may either specifying the argument name followed by argument value. CLI applies
default values to the omitted arguments. Due to the nature of the information, the only argument that can be omitted is
the "comment" argument.
Name
SNMP Trap Host Table
Table Index
IP Address
Password
Comment (optional)
Status (optional)

Syslog Parameters

The following parameters configure the Syslog settings.
Name
Syslog
Syslog Status
Syslog Port
Syslog Lowest Priority
Logged
Heartbeat Status
Heartbeat Interval (seconds) Integer
NOTE
The Heartbeat parameters are advanced settings not available via the HTTP interface. When Heartbeat is
enabled, the AP-600 periodically sends a message to the Syslog server to indicate that it is active. The
frequency with which the heartbeat message is sent depends upon the setting of the Heartbeat Interval.
Syslog Host Table
The table described below configures the Syslog hosts that will receive message from the AP-600. You can configure
up to ten Syslog hosts.
Name
Syslog Host Table
Table Index
IP Address
Comment (optional)
Status (optional)
Type Values
Table N/A
Integer User Defined
IpAddress User Defined
DisplayString User Defined (up to 64
characters)
DisplayString User Defined (up to 254
characters)
Integer enable (default)
disable
delete
Type Values
Group N/A
Integer enable
disable (default)
Octet String 514
Integer 1 – 7
1 = LOG_ALERT
2 = LOG_CRIT
3 = LOG_ERR
4 = LOG_WARNING
5 = LOG_NOTICE
6 = LOG_INFO (default)
7 = LOG_DEBUG
Integer enable (1)
disable (2) (default)
1 – 604800 seconds;
900 sec. (default)
Type Values
Table N/A
Integer 1 – 10
IpAddress User Defined
DisplayString User Defined
Integer enable
disable
delete
Access CLI Parameter
R snmptraphosttbl
N/A index
RW ipaddr
W passwd
RW cmt
RW status
Access CLI
R syslog
RW syslogstatus
R syslogport
RW syslogpritolog
RW heartbeatstatus
RW heartbeatinterval
Access CLI Parameter
R sysloghosttbl
N/A index
RW ipaddr
RW cmt
RW status
129