Ip Access Table Parameters; Filtering Parameters; Ethernet Protocol Filtering Parameters - ORiNOCO AP-600 User Manual

Command Line Interface (CLI)

IP Access Table Parameters

When creating table entries, you may either specify the argument name followed by argument value or simply entering
the argument value. When only the argument value is specified, then enter the values in the order depicted by the
following table. CLI applies default values to the omitted arguments. Due to the nature of the information, the only
argument that can be omitted is the "comment" argument.
Name
IP Access Table
Table Index
IP Address
IP Mask
Comment (optional)
Status (optional)

Filtering Parameters

Ethernet Protocol Filtering Parameters

Name
Ethernet Filtering
Filtering Interface
Bitmask
Operation Type
Ethernet Filtering Table
Identify the different filters by using the table index.
Name
Ethernet Filtering Table
Table Index
Protocol Number
Protocol Name (optional) DisplayString
Filter Comment
Status (optional)
NOTE
The filter Operation Type (passthru or block) applies only to the protocol filters that are enabled in this table.
Type Values
Table N/A
Integer User Defined
IpAddress User Defined
IpAddress User Defined
DisplayString User Defined
Integer enable (default)
disable
delete
Type Values
Group N/A
Interface Bitmask 0 or 2 - no interfaces
(disable)
1 or 3 - Ethernet
4 or 6 - Wireless
5 or 7 - all interfaces
(default is 7)
passthru
block
Type Values
Table N/A
N/A N/A
Octet String N/A
DisplayString 2- 31 characters
Integer enable (1)
disable (2)
delete (3)
Access CLI Parameter
R mgmtipaccesstbl
N/A index
RW ipaddr
RW ipmask
RW cmt
RW status
Access CLI Parameter
R etherflt
RW etherfltifbitmask
RW etherfltoptype
Access CLI Parameter
R etherflttbl
R index
RW protonumber
RW protoname
RW cmt
RW status
126