Alarms; Groups - ORiNOCO AP-600 User Manual

Performing Advanced Configuration

Alarms

This tab has three sub-tabs.
–

Groups

– Alarm Host Table
– Syslog
– Rogue Access Point Detection (RAD)
Groups
The AP can be configured to generate and send alarms/notifications/traps as version 1 or a version 2c. Use the
drop-down menu to select SNMP alarm type.
There are seven alarm groups that can be enabled or disabled via the Web interface. Place a check mark in the box
provided to enable a specific group. Remove the check mark from the box to disable the alarms. Alarm
vary.
Figure 4-19 Syslog Configuration Screen
• Configuration Trap Group
DNS IP Address not Configured
RADIUS Authentication not Configured
RADIUS Accounting not Configured
Duplicate IP Address Encountered
VLAN ID Invalid Configuration
Auto Configuration Failure
CLI Configuration Execution Failure
CLI Configuration Execution Start
CLI Configuration Execution End
Trap Name Description
oriTrapDNSIPNotConfigured
oriTrapRADIUSAuthenticationNotConfigured
oriTrapRADIUSAccountingNotConfigured
oriTrapDuplicateIPAddressEncountered
oriTrapVLANIDInvalidConfiguration
oriTrapAutoConfigFailure
oriTrapBatchExecFailure
oriTrapBatchFileExecStart
oriTrapBatchFileExecEnd
Severity Levels
73