Fm Mode; Selecting Fm Mode; Scan Settings; Audio Settings - TechniSat DIGITRADIO 580 Instruction Manual

FM Mode

Selecting FM Mode

1. Press MODE button repeatedly to select FM mode.
2. For initial use, it will start at the beginning of the FM frequency range (87.50MHz). Otherwise,
the last listened FM station will be selected.
3. To manually change the FM frequency, while FM frequency shows up, turn
SCROLL/SELECT/SNOOZE knob clockwise or anticlockwise to change the frequency by
0.05MHz per step.
4. To automatically scan, while FM frequency shows up, turn SCROLL/SELECT/SNOOZE
knob clockwise or anti-clockwise and then press SCROLL/SELECT/SNOOZE knob, your
radio will skip forward or backward until it reached the next available station.

Scan settings

By default, FM scans stop at any available station. This may result in a poor signal-to-noise ratio
(hiss) from weak stations.
1. To change the scan settings to stop only at stations with good signal strength, press MENU
button, turn SCROLL/SELECT/SNOOZE knob to select 'Scan setting', and then press
SCROLL/SELECT/SNOOZE knob to confirm.
2. Display will show 'Strong stations only?', turn SCROLL/SELECT/SNOOZE knob to select
'YES', and then press SCROLL/SELECT/SNOOZE knob to confirm.

Audio Settings

By default, all stereo stations are reproduced in stereo. For weak stations, this may result in a poor
signal-to-noise ratio (hiss).
1. To play weak stations in mono, press MENU button, turn SCROLL/SELECT/SNOOZE knob
to select 'Audio setting', and then press SCROLL/SELECT/SNOOZE knob to confirm.
2. Display will show 'Listen in Mono only?', turn SCROLL/SELECT/SNOOZE knob to select
'YES', and then press SCROLL/SELECT/SNOOZE knob to confirm.
29