Kustom Signals Talon Radar Operator's Manual page 11

Low Battery
Low Voltage:
Radio Frequency
Interference:
Error:
Hold:
Section 2--Specifications
Flashing "BATT" displayed and an
audio warning tone sounds every 2
minutes when internal battery voltage
falls below approximately 6.6 VDC.
Operator is prompted that
approximately 15 minutes of
transmitter operation remains.
Steady "BATT" displayed when
internal battery voltage falls below
approximately 6.2 VDC (minimum
transmitter operating voltage). The
transmitter is disabled, but locked
speeds will remain. At approximately
6.0 VDC, the Talon shuts itself off.
"RFI" displayed during strong radio
frequency interference. Active speed
displays will blank during this
condition. Locked speeds will
remain.
"ERR x" (where x is a number)
displayed when an internal error in
the operating system is detected.
Active speed displays will blank.
Locked speeds will remain.
"HOLD" is displayed when the
system is not transmitting.
Controlled by the trigger in stationary
mode or remote control in moving
mode.
2.5