Minimum Patrol Speed Set; Moving Mode Test - Kustom Signals Talon Radar Operator's Manual

6.6 MINIMUM PATROL SPEED SET

1. When the speedometer input feature is not used, the
Talon allows the operator to set a minimum patrol speed
of 10, 20, 30 or 40 mph (16, 32, 48 or 64 km/h).
2. To activate this feature, place the unit in the moving
mode and press the PAT SEL switch one (1) time. The
unit will display "Pat" and the last selected minimum
patrol speed will be displayed. Default is the lowest
value (10 mph/16 km/h).
To change the value, immediately press the remote's
LOCK/REL switch. Repeat until the desired value
appears. Once the desired minimum value is selected,
the unit will time out in 2 seconds and the last displayed
value will be accepted as the new minimum patrol
speed.
3. To display the existing minimum patrol speed, press the
PAT SEL switch one (1) time. The current minimum
patrol speed will be displayed in the PATROL window.
After two (2) seconds, the Talon will return to normal
operation.

6.7 MOVING MODE TEST

Drive at a constant speed and compare the patrol vehicle's
speedometer and the Talon's patrol speed display. These
readings should be the same, or within reasonable limits,
allowing for minor speedometer error.
If a discrepancy is found, the radar unit should be removed
from service until the error can be corrected.
Section 6—Testing Procedures
6.7