Switching Modes; Dab Operation; Positioning The Antenna - Goodmans 335105 User Manual

3.3 Switching Modes

1. Press the MODE button on the front panel to cycle through the options DAB, FM, CD,
Bluetooth and Line In.
4 Operation

DAB Operation

4.1 Using DAB For the First Time
1. After switching to DAB input mode for the first time a full scan of DAB stations is
performed automatically.
During the full scan mode, the LCD will display a slide bar that indicates the progress of
the scan, and the amount of radio stations that have been found so far. Once the scan has
finished, the radio will select the first alphanumeric station.
NOTE: The station name will be shown on the top of the display. Information about the
DAB radio station will also be displayed.
2. To listen to the located DAB stations use the >>| / |<< buttons. When you reach the
desired station the DAB Micro System will automatically tune to that station and begin
playback.
NOTE: If no stations were found, or no DAB stations can be received currently [No stations
found] will be displayed. In this case you may need to perform another station scan.

4.2 Positioning the Antenna

Positioning of the aerial will influence the DAB signal quality.
1. To find the optimum position, select the signal error indicator by cycling through the
display modes using the INFO button.
2. Once the indicator is displayed, move the aerial and observe the signal level as shown
by the bar graph. When you are happy with the positioning, perform a scan to capture all
of the available stations.
4.3 Full Scan
1. To activate the full scan press the MENU button.