SC-P20000 Series/SC-P10000 Series User's Guide
Loading and Removing
Poster Board
This section describes how to load and remove poster
board from 0.8 to 1.5 mm thick.
Caution:
Do not place your hand into the parts of the
support bar marked with labels. Failure to
observe this precaution could result in your hand
being caught in the mechanism and being injured.
Note:
The paper that can be used in the printer is detailed in
the following section.
"Supported Media" on page 182
U
Loading Poster Board
Poster board requires space both behind and in front
of the printer. The approximate amount of space
required is shown below. If the printer is set up near a
wall, make sure there is enough space at the rear.
Paper Size
Front (a)
A2
444 mm
A1
691 mm
B2
578 mm
Basic Operations
Paper Size
B1
24 x 30 inch
30 x 40 inch
c
Insert the paper just before printing. The roller
may leave an impression on paper that is left in
the printer.
Note:
The paper that can be used in the printer is detailed in
the following section.
U
Buttons that are used in the following settings
Back (b)
69 mm
316 mm
203 mm
41
Front (a)
880 mm
612 mm
866 mm
Important:
"Supported Media" on page 182
Back (b)
505 mm
237 mm
491 mm