Loading Poster Board - Epson Stylus Photo R3000 User Manual

Epson Stylus Photo R3000
J
With the paper loaded and the printer idle, push
the center of the front manual feed tray to close
the tray.
Tip:
To eject the paper, confirm that the control panel
shows Ready[Cons LCD] and press the + button.

Loading Poster Board

Use the front manual feed tray to load poster board.
Use poster board between 0.7 mm and 1.3 mm thick.
Poster board is ejected from the rear of the printer once
during loading. Leave a space of at least 320 mm
between the rear of the printer and the nearest wall.
A
Turn on the printer.
Note:
Do not eject the front manual feed tray or load
poster board while the printer is operating. Failure
to observe this precaution could damage the
printer.
User's Guide
Basic Operations
B
If the rear support is open, close it.
C
Open the front cover.
D
Push the center of the front manual feed tray.
E
Load the paper vertically with the printable side
face up.
Note:
Be sure to load the paper from the front. Loading
paper from the rear could damage the printer or
cause a malfunction.
24