Cutting The Roll Paper - Epson SC-P20000 SERIES User Manual

SC-P20000 Series/SC-P10000 Series User's Guide

Cutting the roll paper

The printer is equipped with a built-in cutter. You can
cut roll paper after printing by using one of the
following methods.
❏ Auto Cut:
The cutter cuts automatically at a determined
position each time a page is printed in accordance
with the setting of the printer driver or control
panel menu.
❏ Manual cut:
The cutting position is specified on the control
panel, and then the roll paper is cut. A cutline is
printed for manual cutting and can be used as a
guide when cutting paper using the built-in cutter.
c
Important:
Non-genuine Epson media types, such as those
shown below, may not be cut cleanly by the
built-in cutter. Furthermore, cutting the following
media types may damage or reduce the lifetime of
the built-in cutter.
❏ Fine art paper
❏ Canvas
❏ Vinyl
❏ Matte poster board
❏ Adhesive paper
❏ Banner media
Cut these media types with commercially
available scissors or a cutter in the following
manner:
Keep the d button pressed to feed the paper so
that the cut location is below the poster board
support. Cut the paper using scissors or a
third-party cutter.
Basic Operations
Note:
The cut end may bend when paper that is wider than
44 inches is cut by the SC-P20000 Series. Improve
cutting by pressing the part, as seen below, to use the
part in a raised position. However, depending on the
type of paper, the edge of the paper may catch on the
raised part.
Press the back side of the part, as shown below, to
return the part to its original position.
Setting Auto Cut
You can specify the method either on the control
panel or the printer driver. Note, however, that the
setting selected with the printer driver takes priority
when the printer driver is used.
35