Epson SC-P20000 SERIES User Manual page 157

SC-P20000 Series/SC-P10000 Series User's Guide
Paper feed sensor
Using a cotton swab, wipe away any dust or
stains on the glass section of the sensor. To
avoid spreading the dirt, wipe from the inside
to the outside. If it is particularly dirty, dampen
the cotton swab with water containing a small
amount of neutral detergent, and then firmly
wring the cotton swab before using it to wipe
the surface. Then, wipe away any moisture with
a new, dry, cotton swab.
c
Important:
Be sure not to touch or bend the rollers and
metallic parts (C, shown in gray) while
cleaning. This could cause prints to get dirty.
E
After cleaning, close the printer cover.
Cleaning the Paper Slot
A cloth is attached to the roll paper feed slot, to catch
paper particles and dust that are settled on the paper
surface and edges.
Use the supplied cleaning sheet (or consumable) in
the following procedure to remove dust caught by the
cloth in the roll paper feed slot. Purchase a
consumable when the supplied cleaning sheet has
been used.
"Options and Consumable Products" on
U
page 179
Maintenance
c
Important:
❏ Always use a new cleaning sheet. If you reuse
a cleaning sheet, it may actually increase the
amount of dirt on the target area.
❏ Do not feed the cleaning sheet. Doing so may
causes paper jams.
❏ Do not clean the paper slot with anything
other than a cleaning sheet. Doing so may
damage the cloth.
❏ Clean the paper slot with a cleaning sheet
once a year, as a guideline.
A
Check that there is no paper loaded.
Remove any paper if it is loaded.
"Basic Operations" on page 31
U
B
Confirm that the printer is off.
C
Peel off the protective sheet from the cleaning
sheet.
The shaded part, A, is an adhesive sheet. Do
not touch it with your hands or let it stick to
other objects.
D
With the adhesive side facing you, insert the
edge of the sheet about 1 cm into the paper slot,
and then pull it out. Repeat this 2 or 3 times.
157