Removing Paper From The Auto Take-Up Reel Unit - Epson SC-P20000 SERIES User Manual

SC-P20000 Series/SC-P10000 Series User's Guide
D
Attach flange L to the end of the last pipe you
attached.
Flange L is not secured here. After placing it in
the slack part of the paper wound around the
auto take-up reel unit, make adjustments.
See the following procedure for information on
placing into the slack part and for details on
adjusting flange L for the tensioner.
"Attaching the Paper" on page 50
U
Removing Paper from the Auto
Take-up Reel Unit
This section describes how to remove paper from the
auto take-up reel unit.
Caution:

Removing paper from the auto take-up reel unit

requires two workers, one on each end of the roll.
A single worker working alone could drop the roll,
resulting in injury.
Buttons that are used in the following settings
Basic Operations
A
Set the Auto to Off.
B
Move the support bar to the storage position.
C
Remove the tensioner.
D
Cut the paper and take it up until it is all on the
auto take-up reel unit roll core.
"Manual cut method" on page 36
U
After cutting the paper, support the end to
prevent the printed surface touching the floor;
until the paper is all taken-up. Keep the Manual
switch pressed in the take-up direction (either
Forward or Backward).
54