Setup Menu - Epson SC-P20000 SERIES User Manual

SC-P20000 Series/SC-P10000 Series User's Guide

Setup menu

Printer Setup
*1: Only displayed when the optional hard disk unit or Adobe PostScript 3 Expansion Unit has been connected.
* Default setting
Roll Paper Setup
Item
*
Auto Cut
On
Off
Refresh Margin *
On
Off
Page Line *
On
Off
Roll End Option Continue
Stop Printing
Reprint
Roll Paper Ten-
1 to 5 (3
sion
Auto Loading *
On
Off
Feed Lateral Ad-
Normal
just
On
Off
Using the Control Panel Menu
*
*1
*
)
*
Description
Choose On to automatically cut roll paper using the built-in cutter as
each page is printed or Off to disable auto paper cutting. The
setting selected with the printer driver takes priority when the
printer driver is used.
If On is selected during borderless printing, the printer will
automatically trim the leading edge to remove any ink stains that
may have been left by the previous copy; to disable this feature,
choose Off.
If Auto Cut is Off, you can choose to print (On) or not print (Off) cut
lines on roll paper. Cut lines are not printed if Auto Cut is On or
when cut sheets or poster board is used.
Note, however, that if the roll width selected with the computer is
narrower than the paper loaded in the printer, cut lines will be
printed regardless of the option selected for Auto Cut.
The setting selected with the printer driver takes priority when the
printer driver is used.
Select the action to perform for a roll after replacement: print the
remaining data (Continue) / do not print (Stop Printing) / print
again from the beginning (Reprint).
This setting is used if Extra High is set as one of the following
settings: Paper menu - Custom Paper Setting - Roll Paper Tension,
or Paper Configuration - Roll Paper Back Tension in the printer
driver. If the paper wrinkles while printing even if Feed Lateral
Adjust is set to Off in Printer Setup - Roll Paper Setup from the
Setup menu, and Roll Paper Tension is set to High, select Extra
High and then set the back tension. Higher values produce higher
tension.
Normally, leave the setting at On.
If you experience problems with automatic loading when you use
commercially available paper because of slipperiness, extremely
large curls, lack of tension, or other problems, set to Off.
Remove all paper before configuring this setting. If paper is loaded,
the setting cannot be changed.
This should usually be set to Normal.
To prevent paper from being fed askew while printing, set this to
On. When wrinkles appear while printing on thin paper, set this to
Off. If the same items are set in Custom Paper Setting from the
Paper menu, priority is given to this setting.
130