Test Run - Grizzly G0817 Owner's Manual

Test Run

Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components are functioning correctly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The Troubleshooting table in the
SERVICE section of this manual can help.
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly set up machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.
The test run consists of verifying the following:
• Motor powers up and runs correctly.
• Emergency Stop button works correctly.
• Foot brake pedal works correctly.
To test run machine:
1.
Clear all setup tools away from machine.
2.
Press Emergency Stop button in.
3.
Connect machine to power by inserting power
cord plug into a matching receptacle.
Model G0817 (Mfd. Since 05/16)
4. Insert key into Master Power Key Switch,
then rotate switch to "1" position (see Figure
40). This turns incoming power ON.
5.
Twist Emergency Stop button clockwise until
it springs out (see Figure 40). This resets
switch so machine can start.
6. Press ON button (see Figure 40) to turn
machine ON. Verify motor starts up and runs
smoothly without any unusual problems or
noises.
Master Power
Key Switch
ON Button
Emergency
Stop/Reset
Button
Figure 40. Location of power controls for turning
machine ON and OFF.
7. Press Emergency Stop button to turn machine
OFF.
8. WITHOUT resetting Emergency Stop button,
try to start machine by pressing ON button.
Machine should not start.
— If the machine does not start, the safety
feature of the Emergency Stop button is
working correctly.
— If the machine does start, immediately
turn it OFF, disconnect power, and con-
tact customer service for assistance. The
safety feature of the Emergency Stop but-
ton is NOT working properly and must be
replaced before further using the machine.
-27-