Table of Contents
Advertisement
Available languages
Available languages
DIAMOND142L
13
3.7 Linking
Several units may be interconnected in order to control all further slave units to the same effect of the
master unit.
1. Connect the DMX OUT of the master unit via 3-pole XLR cable to the DMX IN of the first slave unit.
2. Connect the DMX OUT of the first slave unit to the DMX IN of the second slave unit, etc. until all units are
connected in a chain.
3.8 DMX mode
• Press the button FUNC so many times until the display shows the DMX address (fig.7).
• Press the buttons UP and DOWN to select the desired value (001 - 512).
• After the setting value for to confirm, press the button ENTER.
NOTE: In case of DMX cable disconnecting or no DMX signal is detected, the DMX address on LED DISPLAY
keeps flashing. Please check the DMX cable connection.
Fig.7
3.9 DMX addressing
To able to operate the DIAMOND142L with a light controller, adjust the DMX start address for the first a DMX
channel. If e. g. address 33 on the controller is provided for controlling the function of the first DMX chan-
nel, adjust the start address 33 on the DIAMOND142L. The other functions of the light effect panel are then
automatically assigned to the following addresses. An example with the start address 33 is shown below:
Number of
Start address
DMX Address
Next possible start
Next possible start
Next possible start
DMX channels
(example)
occupied
address for unit No. 1
address for unit No. 2
address for unit No. 3
8
33
33-40
41
49
57
Advertisement
Table of Contents
