ProLights Diamond142L User Manual page 32

DIAMOND142L
12
In "Sound" modes, the show is controlled by the audio input signal detected by the integrated micro-
phone(6), which sensitivity is regulated by the respective regulator (5).
To set the LED rotation speed use the LED rotation regulator (7). When it is set to the centre, the show is
static, otherwise the show rotates on right or left, depending on the regulator direction. The more the regu-
lator is near to the left or right bounds, the greater is the rotating speed.
3.5 LED settings
In LED modes, the unit allows to change the led beam settings.
• Press the FUNC button so many times until the display shows one of the modes in the following table.
• Use the UP and DOWN buttons to choose the desider mode.
• Press the ENT button to confirm.
DISPLAY FUNCTION DISPLAY FUNCTION
LED Color Cyan
Color Looping Green
Color Random Blue
Red Purple
Yellow White
3.6 Slave Mode
This mode will allow you to link up the units together without a controller. Choose a unit to function as the
Master. The unit must be the first unit in line; other units will work as slave with the same effect.
• Press the button FUNC so many times until the display shows [SLA ] (fig.6).
• Use standard DMX cables to daisy chain your units together via the DMX connector on the rear of the
units. For longer cable runs we suggest a terminator at the last fixture (see page 14).
Fig.6