Setting Up An Image For Print - Epson Fast T-Jet 3 PLUS User Manual

T-Jet3 PLUS User's Manual
S S Since the pretreatment process can take some time to dry, we
re re recommend you pretreat as much of the production run as
p p possible to avoid delays due to drying time (Do this only after
b b becoming profi cient with the Non-Textile Primer/Pretreatment).

Setting up an Image for Print

To setup an image for print, you must use a graphic application such as
FastARTIST, Photoshop, or CorelDRAW. Any these applications are capable of
printing to FastRIP, but for this Reference Guide we will setup the image using
FastARTIST. The steps required for printing with other graphic applications will be
very similar- please consult your application's Owner's Manual if needed.
1. Setup the printing area in which you will be printing on. To do this you will
need a measuring tape and will need to measure the width and height of
the Non-Textile item. From within FastARTIST select File > FastRIP Setup.
2. From the Setup window, select Page Setup. In
the Page Setup window, select Custom under
the Page option. Enter the Height and Width of
the Non-textile item you have measured. After
entering the values, click OK to return to the
workspace.
3. Select Layout > Page Size. For the Page Size,
enter the Height and Width of the Non-textile
item you have measured. After entering the
values, click OK to return to the workspace.
The non-textile item dimensions will now be
represented by a black box located within the
workspace. If this is not displayed, click View >
Show Page Size to view the black box.
Version 1.1 Revised July, 2008
72