Epson Fast T-Jet 3 PLUS User Manual page 27

5. After the Chip Block is in place, use a Chip Block Support to secure it.
The Chip Block Support has arrows in the center bar, pointing upward. Use
these arrows for orientation and place the single end of the Chip Block
Support into the Chip Block. Press the back end into the Print Carriage. Note
the rear placement of the block support.
6. Locate the Chip Block with the black sticker and place
this into the Print Carriage as well, adjacent to the
previously installed Chip Block.
7. Secure this Chip Block into the Print Carriage with the
second Chip Block Support.
8. Located on the bottom of the Print Carriage is an
currently holds 8 ink lines. DO NOT remove any of the 8 lines from the guide
until you are ready to connect the bulk ink cartridges.
9. Before proceeding to the next step, ensure all of the ink bottles are fi lled in
accordance with earlier instructions and none of the Ink Line Clamps are
engaged. DO NOT not connect any of the Ink Lines to the Ink Bottle at this
time.
Disengaged
Chapter 2 - Unpacking and Setup
Ink Line Guide that
17
Engaged